X-RAY SOUND
A single Snare Mic can replace the traditional multi-mic setup needed to capture the full spectrum of a snare drum. Proper positioning even lets you hear the bottom snares through the top head.
BUILT FOR THE JOB
A solid brass headframe with a mildew-resistant dust filter protects Snare Mic from stick hits, dust, and debris on stage or in the studio.
28
dB
OFF-AXIS REJECTION
Snare Mic captures a snare drum's true impact, body, and timbre while rejecting up to 28dB of off-axis sounds. This means clear, mix-ready sonics with optimal phase coherence straight out of the microphone.
NOT AN instrument mic that works on snare drums.
A MIC THAT IS PURPOSE-BUILT FOR SNARE DRUMS.
AT HOME
Professional sound straight into your audio interface.
IN THE STUDIO
The power of a condenser with the rejection of a dynamic.
ON THE ROAD
Studio sound, built for the rigors and abuse of touring.
ONBOARD SOUND SHAPING
Unlike the filters in your DAW or console, these settings affect Snare Mic’s entire sonic spectrum.
Specifications
Type | End-address pressure gradient FET condenser |
Capsule | 32mm |
Polar Patterns | Cardioid |
Freq. Response | 20Hz-20KHz |
Dynamic Range | 135dB minimum |
SPL Handling | >135DB (0.5%THD@1000Hz) |
Impedance | >150 ohms |
Self-noise level | < 15dB-A |
Signal-to-Noise Ratio | 79dB |
Sensitivity | -51dBV/Pa (0dB=1V/Pa 1KHz) |
Connector | 3-pin XLR |
Power | Requires 48v Phantom Power |
Dimensions | 109 x 50mm (mic only) 112 x 71mm (with mount) |
Weight | 309g (mic only) 407g (with mount) |
DIAGRAMS
IN THE BOX
SNARE MIC / ADJUSTABLE HARD MOUNT / CORDURA® MIC BAG
